Improved Dome for Flashforge Creator Pro

(for a handle for this dome please see thing http://www.thingiverse.com/thing:2325371)

(note: more information about the filament guide tube holder I use with this dome can be found here http://www.thingiverse.com/thing:1167693 )

Update (Jan 2017) FlashForge seems to ship the 2016 models with a new dome that is made of a single piece. This is an improvement over the older version which as made from flat sheets of clear plastic attached by screws. However, the new dome still use the same T shape cut in the back for the filament tubes. The Makerbot dome described here has a better tube path IMO since the tube rise *inside* without any cut in the back of the dome.

Update (Feb 2016): Humanisticnick@ reported that this dome worked also with the FlashForge Creator Wooden: "I just needed to trim down my filament guide tubes".

This thing describes an improved dome for Flashforge Creator Pro 3D printer. This dome has a few advantages over the stock one.

* Better filament guide