Thingiverse
Replacement Parts
Go to Model
Improved Drawer Rail Guide/Retainer
15
Downloads
15
Likes
0
Makes
If you find this thing useful, please consider sending a tip. :)
https://paypal.me/cdsmakestuff
The common plastic drawer rail guides are junk… never had a piece of furniture that at least one didn't break.
Replace them with an improved version.
The opening that goes over the rail on this version is 30mm wide x 7mm tall.
Most drawers use (roughly) ½" (12mm) boards for the sides/back… a #6 x ¾" (19mm) is the best size for installing these.
You will need to mark and (pre)drill new holes for the replacement screws.
Printed in PLA+, 4 walls, 6 top/bottom layers, 20% triangles infill
https://paypal.me/cdsmakestuff
The common plastic drawer rail guides are junk… never had a piece of furniture that at least one didn't break.
Replace them with an improved version.
The opening that goes over the rail on this version is 30mm wide x 7mm tall.
Most drawers use (roughly) ½" (12mm) boards for the sides/back… a #6 x ¾" (19mm) is the best size for installing these.
You will need to mark and (pre)drill new holes for the replacement screws.
Printed in PLA+, 4 walls, 6 top/bottom layers, 20% triangles infill
cdsmakestuff also publishes on
47 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
