Thingiverse
Improved Mecanum Meccano Compatible
von Storming_Moose
4
Downloads
3
Likes
0
Makes
N20 boss on one side, on the other side use a double crank or a bush wheel to connect to Meccano axles.
Two Different Rollers require different attachments: (for each wheel)
40 M4 hex nuts and 8 30mm M4 bolts or
40 Meccano nuts and 8 111D bolts. One less nut can be used so the head of the bolt could be recessed into the roller. The bolt is just a little short sometimes.
Rollers are printed in TPU, wheel in PLA.
Use the 10 axle one and put it in your slicer, multiply it by 3 and mirror two of them,
Tolerences are close, I had to trim the elephants foot from some of the rollers.
https://youtu.be/-3dxDYtFfpw
Two Different Rollers require different attachments: (for each wheel)
40 M4 hex nuts and 8 30mm M4 bolts or
40 Meccano nuts and 8 111D bolts. One less nut can be used so the head of the bolt could be recessed into the roller. The bolt is just a little short sometimes.
Rollers are printed in TPU, wheel in PLA.
Use the 10 axle one and put it in your slicer, multiply it by 3 and mirror two of them,
Tolerences are close, I had to trim the elephants foot from some of the rollers.
https://youtu.be/-3dxDYtFfpw
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
