Thingiverse
*Improved* Mobula6 Pinch mount
di Tokyo_Dom
20
Download
23
Likes
0
Makes
This is an improved version of my Mobula6 canopy Pinch Camera adapter. This one uses the camera-holding design from RAB's awesome folded canopy, but I wanted to have the protection, light weight and instant angle adjustability of the Mobula 6 canopy.
I had previously used a design which push fits over the camera PCB, but this was difficult to put on, and often popped out during hard crashes. This should solve that problem! As a bonus it is also a tiny bit lighter.
Mobula6 canopy + side screws comes to 0.70g (you need to trim the opening a little bit for the larger Pinch lens, otherwise it will be in the camera feed). This adapter weighs 024g for a total of 0.94g. The Pound mount weighs 1.0g, most other printed designs are over 1g, and have no angle adjustability, plus they rest directly on the FC. This means that any hard inverted crash will put pressure on the FC, possibly turning it into a taco, or cracking the solder joints on the chips.
There are some folding print design
I had previously used a design which push fits over the camera PCB, but this was difficult to put on, and often popped out during hard crashes. This should solve that problem! As a bonus it is also a tiny bit lighter.
Mobula6 canopy + side screws comes to 0.70g (you need to trim the opening a little bit for the larger Pinch lens, otherwise it will be in the camera feed). This adapter weighs 024g for a total of 0.94g. The Pound mount weighs 1.0g, most other printed designs are over 1g, and have no angle adjustability, plus they rest directly on the FC. This means that any hard inverted crash will put pressure on the FC, possibly turning it into a taco, or cracking the solder joints on the chips.
There are some folding print design
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!