Improved Riser for K1/K1C

Hey guys! Sadly my K1 is sadly dead. I will no longer be able to see if updates will work. This means I will no longer be updating the model because if I make an update, it will not function and I will not be able to tell. Thank you all for reading this message.

This is a riser that gives 5 cm elevation with an empty back. The empty back is for people using the CFS with the PTFE tube sticking up. I hope to publish a version with a closed back for all of the non CFS users. Also, if it is too loud you can put electrical tape in the corners and it should be more quiet.

You will need 1 Corner, 1 Corner2, 2 Connecters, 1 Connecter2, and one of each Endcap. Assembly is straightforward, just look at the pieces.
You can use Connector-Edged instead of Connector if you want.

Connecter2 IS DIFFERENT, you should be able to distinguish it from its slant on top
Corner2 and Corner are different as well, though I have not made them noticeably different. It is important that you print one of each