[Improved Wide Wheel] Xbox One controller mini wheel

Increased height of wide wheel stalk by 1.5mm.
I found that this was necessary as the original design of the wide wheel would run into the rack and pivot due to the flex of the 3d printed components - This was especially the case when turning the wheel and using uneven force on opposite sides of the wheel.

Also attached are the relevant stls required for printing the rest of the mechanism.

Print the frame which matches your controller. One of the graphics will aid you in identifying the type of controller you have.

Design is a derivative of pixel2's design.
Link to original design:
https://www.thingiverse.com/thing:3049220#Summary

The pivot requires a 1.2mm metal rod [paper clip/push pin/etc] - I used a paper clip.