ImpulseRC Apex DJI/HD Stack Covers

This is a sidewall/stack cover for the ImpulseRC Apex DJI edition, mostly to keep grass out and hold onto my pigtail. This is designed to work with the Antenna mounts created by Domsmod, found here:
https://www.thingiverse.com/thing:4515525

This antenna mount holds the air unit up 1.5mm from the carbon, and hence why there is a 1.5mm bumper on the back standoffs. If you wanted to use another mount, just lop off that bumper at the bottom, and add 1.5mm back at the top.

One has a LiPo pigtail holder, and the other is blank. You will have to mirror one of them in your slicer before printing, else you will end up with two for the same side.

Note that these do not come off without disassembly, unlike the Diatone Roma F5 covers. You could potentially cut them and slide them over.

Designed for TPU, you can print in hard materials but no guarantee the measurements are precise enough, this was really roughly made in Windows 3D Builder.