Thingiverse
Incense holder (OpenSCAD)
von gaellafond
44
Downloads
30
Likes
2
Makes
Another incense holder, inspired on the Catch design. I made mine using OpenSCAD because I like using OpenSCAD to draw everything, and because the shape is simple enough.
I made it very easy to modify. There is a large range of parameters and I used the "animation" function to verify that it works well with pretty much any values. I build it using a nightly build of OpenSCAD, but I didn't use any funky features. This should work with older version of OpenSCAD.
[2017-07-14] UPDATE: The hole for the incense was too thigh. I added a big 1mm clearance.
[2017-07-15] Version 2: The earlier version of the holder was quite small and not very effective at catching ashes. The version 2 is 8cm in diameter. It is also more stylish, it looks more like a bowl and less like a cap.
I made it very easy to modify. There is a large range of parameters and I used the "animation" function to verify that it works well with pretty much any values. I build it using a nightly build of OpenSCAD, but I didn't use any funky features. This should work with older version of OpenSCAD.
[2017-07-14] UPDATE: The hole for the incense was too thigh. I added a big 1mm clearance.
[2017-07-15] Version 2: The earlier version of the holder was quite small and not very effective at catching ashes. The version 2 is 8cm in diameter. It is also more stylish, it looks more like a bowl and less like a cap.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
