Incense Holder V1 (Parametric)

Recently I lost my incense holder. The original one was made out of brass but was too small and somewhat unstable, especially if you put in more than one incense stick into it. So, I decided to quickly design one with some stability improvements and print. The stand incorporates an M12-1.75 threaded bottom portion and an unthreaded upper portion as well as a wide base. The stand is quite stable to use without the M12 nut so the hardware is totally optional. The threaded portion is there in case one wants to weigh down the stand by threading one or two M12 nuts. The current design is parametric. You can change the height of the threaded portion as well as the unthread portion. The base dimensions are also parametric. Finally, center hole is also parametric. I recommend 3 mm for using with single incense sticks or 4mm or 5mm if you intend to put multiple incense sticks into the stand. The included print profile prints 3 stands with 3 mm center hole. It also uses 0.6mm hot end with 0.3 mm