Inclinometer

###Print these parts:
- Scale_Holder
- Clamp_Jaw

There are two clamp bars one has a hole at the end the other has a hole in the middle. Use the one you prefer.
- Clamp_Bar // Hole at the end
- Clamp_Bar_P // Hole in the middle

These parts are small and will require rafts:
- Pointer
- Clamp_Wedges

Print Angle-Throw-Gauge.pdf.
###Assembly

- From Angle-Throw-Gauge.pdf cut out a scale.
- Use 3M 77 Spray Adhesive or similair, to fasten the printed scale to the scale holder.

#### Assemble the clamp:
- Put a wedge through the hole in the Clamp Jaw
- Push the clamp bar through the hole in the Clamp Jaw
- Slide the wedge and check that the clamp jaw is locked
- Four wedges are printed. Use the one that works best
####Pendulum and Axle
- Bend a paper clip to make the pendulm and axle.
- Push the Clamp Bar into the square hole on the Scale Holder.
- Align the hole in the Clamp Bar with the hole in the Scale Holder. A paper clip through the hole will help alignmen