Indoor Wall Trellis

Designed for Pothos plant to give it a guided path up a wall with its vines secured by the clips.Main Body can be tilled with itself to form large wall structure and can be offset to create many paths. Ends allow for pattern to terminate cleanly. Holes for clips to pop into are on main body and both ends allowing further control of the plants path and keep it from directly hugging the wall.Four small holes in main body and two in each end for nailing to wall mean no need to measure to get perfect alignment between pieces.Print SettingsMain and end pieces have no special requirements, no support or brim needed.Clips should be printed on their side with support enabled. Normal support and snug setting has worked best.When slicing clips in CrealityPrint "Slice gap closing radius" must be changed.Found setting to 0.04 works well, just ensure that the gap between the halves of the clips is not filled by the slicer or clips will be fused.