Thingiverse
Inductive/Capazitive Mount for E3D v6 Bowden Carriage
di TheZippyMan
23
Download
11
Likes
0
Makes
This is a remix of http://www.thingiverse.com/thing:638496.
It uses a 17/18mm inductive/capazitive ZProbe.
You will need to print a low profile fan duct for your E3D hotend.
Be sure to print this part at a 100% Infill, because the sensor doesn't seem to fit properly. Mine at 30% broke. To fit the sensor heat the part or the sensor a little bit up and thread it carefully into the part.
It uses a 17/18mm inductive/capazitive ZProbe.
You will need to print a low profile fan duct for your E3D hotend.
Be sure to print this part at a 100% Infill, because the sensor doesn't seem to fit properly. Mine at 30% broke. To fit the sensor heat the part or the sensor a little bit up and thread it carefully into the part.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
