Thingiverse
Inductive Filament Sensor
von Livewire
19
Downloads
13
Likes
0
Makes
Use the SN04-N Inductive Proximity Sensor and a 16mm Ball bearing as a low friction filament sensor
Wanted to put the sensor to use and didn't use it for bed leveling and wasn't keen on the micro switch versions.
Its not perfect, I need to make it a bit easier to feed the filament through, it was easier once i straightened out the filament maybe make the hole bigger and line it with PTFE tubing
Wanted to put the sensor to use and didn't use it for bed leveling and wasn't keen on the micro switch versions.
Its not perfect, I need to make it a bit easier to feed the filament through, it was easier once i straightened out the filament maybe make the hole bigger and line it with PTFE tubing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!