MakerWorld
Hueforge & Lithophane
Vai al Modello
Infernos Edge
6
Download
18
Likes
3
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Orange Transmission Distance: 7PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic White Transmission Distance: 5This print uses 4 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #8 (0.72mm) swap to OrangeAt layer #16 (1.36mm) swap to YellowAt layer #20 (1.68mm) swap to White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp pubblica anche su
338 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
