Infill Pattern Square Planter Pot Base

Here is my Square Planter Pot Base design, just posted on MakerWorld available for free download. 🌿 In order to create the special infill design the way I did you need to print the color changes by layer. No AMS is necessary for this so it will save filament when you are multicolor printing. The .3mf file has it already setup to do this. I included an image below to show how the changes in color show on the scrollbar when you preview the .3mf. If you have to do it by scratch do the following: click preview > click the scrollbar layer you want to change the color > right click the scrollbar > click change filament Repeat this for each layer you want to swap colors. You must have the bottom layer be clear. Then set the pattern color you want in the middle once the infill is visible to be shown. Then move up a few layers until the infill top layer starts to fill in and make the top layer clear again. This will allow the top and bottom layers to be clear and only the infill to pattern to