Thingiverse
Infill Test
von trafficKone
6
Downloads
1
Likes
0
Makes
This is a test so that you can see the different type of infill supported by your 3D printer software.
Print the levels at different infill percentages Level height is 10mm.
Print with 0 top layers
Print the levels at different infill percentages Level height is 10mm.
Print with 0 top layers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!