Infimech TX - Simple Clean Filament Sensor Relocation Bracket

This is a simple Relocation bracket for the Filament Sensor on the Infimech TX printer. This is really made to go along with the Infimech Filament Sensor Case located here: https://www.thingiverse.com/thing:7006594

This uses the PC4-M8 fittings that come with the Infimech TX. I have a tool to help you screw the PC4 fitting in. It's located here: https://www.thingiverse.com/thing:7005667

I used Countersunk 12mm M4 Screws for this. You may be able to use your existing screws, but I don't know. I didn't check.

There's really not much else I need to say about how to use this.