Info Orbs Case

This is my case for the Info Orbs by Brett Tech found below. I designed this wider than it needed to be because I planned to put a speaker on top and so it needed the space. That is also why there's a massive column inside to support the weight of the speaker.

You will need the following;

For the 3D print

1x Orbs Display Mount
1x Orbs Display Cover
1x Orbs Main Body
1x Rear Cover
3x Buttons
4x M3x10 screws
4x M3x20 screws
and
8x M3 Nuts

For the Orbs

Either buy the kit from the link below or source parts yourself

1x ESP32
5x round TFT displays
1x USB-C breakout board
3x pushbuttons
+misc soldering/PCB stuff


Everything is designed to be printed without supports and 5 or 10% infill.

ASSEMBLY:

- You will want to solder the 7-pin female headers onto the PCB as the case is designed with these in mind for repairability should a display break.

- Use the straight 7-pin male connectors for the displays, not the 90-degree bent pins.

- Solder