Ingress Badge

I have included the f3d file to make it completely customisable for Ingress players
There are two main sketches to edit under lanyard:
1. Agent Name
2. Agent Faction

For info, the Ingress font is Coda, you will need to download this and install it if you want the badge to match this font. I also had a lot of problems printing in this font with raised text, the best solution i found for a 0.4mm nozzle was to keep the font size at 9, any smaller and you start to lose lines all over the place, even with thin walls on it was a nightmare. The embossed text was not as much of a problem, but it can look a little untidy in places.
Export and check it carefully, especially the raised text, in your slicer before you print.

At 0.15 a bed of 6 takes about 13hrs to print

I set a personal width limit of 75mm to stop it looking stupid, if the agent name was too long and did not fit, i abbreviated the name and added a * to the end of the name, but its your call obviously.

To change t