Inhaler Case

My daughter was recently diagnosed with mild exercised-induced asthma, which requires her to carry an inhaler. She wanted to get a case to put it in so that it wouldn't discharge in her backpack. In addition to the print the model uses one piece of hardware - A 2mm 304 Stainless Steel Round Rod to hinge the lid to the case. I used the following and cut it down to size - https://a.co/d/eeaWkKi - Note that the diameter of the hole for the pin in the model is 0.2mm bigger than the rod, which printed for a snug fit of the rod with my P1S. The .3mf file is set and good to go for my P1S, but you may need to adjust depending on materials (obviously). If you decide to instead print from the .stl files, you will need to rotate the lid onto its top. The model prints with no supports needed in both PETG and PLA. I will update the post with a picture of the final product.