Slicer Discord
Inland Spool Adapters – Modelo 3D imprimible de MakerWorld MakerWorld
3D Printer Accessories

Inland Spool Adapters

25 Descargas
10 Likes
16 Makes
Ver Modelo
The only Inland Spool adapter I've found actual success with. Any other spool adapter, using electrical tape, or other solutions were not at all successful for me, and would get AMS jamming every hour or so….but since using these, haven't had a single jam/pause in my prints. The inland spools have different diameters, so make sure you use the correct one: The standard PLA rolls typically have a LARGE diameter, so print the LARGE female and male sidePLA+, high-speed, etc typically use the SMALL diameter, so print the SMALL female and male side. In order to install, you need to peel off the ENTIRE cardboard sides, and then slide it onto the adapters while leaving the cardboard center intact. Its best to do it one side at a time to avoid having the roll fall over and completely unwind leaving it a big tangled mess…..learn from my mistakes. Best to locate the side that has the slot cut out so it can slide and stay in place on the adapter, then move to the other side and remove and
Categoría
3D Printer Accessories
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
¿Por qué?
2 colores
Pieza única 2 colores / AMS
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Colores
2 (AMS/MMU recomendado)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección