Thingiverse

Inlay Coaster

von Jdcustardjr

1 Downloads

1 Likes

0 Makes

Nice inlaid coaster. 101.60mm x 101.60mm x 3.17mm or 4" x 4" x 1/8" Printed well just make sure you have your glue or adhesion material completely under the print as the corners are very thin and will curl if you don't have good adhesion. Also you must trim the bottom of the (Shield and weapon inlay) pieces only the sword handle and the axe handle and axe head need attention the shield and Sword blade fit perfectly, then super glue them into the coaster.

bar beer beerholder drink drinkcoaster drink coaster drink holder entertaining bar beer beerholder drink drinkcoaster drink coaster drink holder entertaining

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat