Inline Filament Clip

NOTE** PLEASE USE THE PROFILE I UPLOADED. I changed a lot of settings including the percentage of wall thickness for the arachne walls. If you don't like how tight the model is on your filament, feel free to size up the model a few percentage points. Also, it's not designed for filament to go into the side that faces the build plate. That side is a tiny bit smaller so that the filament doesn't go all the way through. It takes some oompfh to get the filament into the clip but it shouldn't just break over and over again. If it's doing that, you're likely backwards. This is the first model I ever felt was polished enough to upload. I have an AMS for my P1S and an AMS Lite for my A1. Specifically for my AMS lite, I had an issue where, because I hang my filament spools from a closet rod instead of being in the actual AMS lite housing, the hangers I printed for them ride real close on the sides. This means that traditional “over-edge” clips would need to be removed fo