Inmoov Forearms Modded

Many Thanks to -Mr Gael- "Inmoov" Designer

Forearm’s- Part-A -Part-B-“ Plus” Upper and Lower Wrist

This Mod joins the Four smaller sections into Two-,, the forearms total height is just under 200mm high,,, so make sure you can print this high before starting !!,
I have included the small section pieces if you can’t print that high, the bolt
hole has been reduced to 5mm to increase strength- the pictures give you all the information you
need there is no change to the actual design except for the 5mm bolt hole, and 2.2mm extension to
reduce the angle and add a bit more strength,, all pieces where hand joined and are error free-
the Bicep servo mount has been modded to have a 5mm hole to match the forearms-

Slow down the printing speed due the small Footprint and because how tall it is, but also because it
Is a thin object the infill will have short rapid movement this will make the object become unstuck if
they became too violent so set infill speed to- 60mm/sec- a