Thingiverse
Inner Dimension Calibration Test
3
Download
0
Likes
0
Makes
Wanted a quick test for calibrating inner dimensions. On large prints, my ID was off as much as .0.8 mm, While my OD on all measurements were 0.1-0.2mm.
In Cura, you're going to be adjusting horizontal expansion to get those measurements dialed in.
If you scale, would suggest scaling by whole number factors.
In Cura, you're going to be adjusting horizontal expansion to get those measurements dialed in.
If you scale, would suggest scaling by whole number factors.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
