inner thought hueforge

This is a little different from the usual ones we make but just change the yellow and red for light grey and blue grey if you want the normal black and white look.not for commercial useProject: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 150x150mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA PolyLite Grey Transmission Distance: 1 PLA PolyLite White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #8 (0.72mm) swap to Blue Gray At layer #13 (1.12mm) swap to Grey At layer #20 (1.68mm) swap to White for the rest.