Thingiverse
Insert for 2020 Extrusion
by FrisbeeD
3
Downloads
0
Likes
0
Makes
The flat end sticks out enough to use CA glue or Acetone to attach to whatever you want.
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
Original intent was to attach after a print so I didn't need to waste filament on support.
Note: The fit is not tight. Probably will not hold vertically. I've included the .f3d file if you want to make changes.
Happy Making!
FrisbeeD also publishes on
13 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
