Thingiverse
Insidepanel mount for BLV mgn Cube
von BePrint
48
Downloads
27
Likes
0
Makes
Yet another remix :D
This is for the original Panel Walls fron Ben Levi!
I have made a fixing for the inside plates, which allows them to take out easily.
You need to mount four of the panelholder on the side extrusions and two support brackets, one on front and back extrusion each. Of course you can also use the corners of the BOM if you still have some left.
The panelholder have longholes, so you can adjust a bit. You don't need screws for the plates, just lay it down and remove it easily
If you like my work, please buy me a coffee ^^
[](https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=4L74MQF85CTEJ&source=url)
This is for the original Panel Walls fron Ben Levi!
I have made a fixing for the inside plates, which allows them to take out easily.
You need to mount four of the panelholder on the side extrusions and two support brackets, one on front and back extrusion each. Of course you can also use the corners of the BOM if you still have some left.
The panelholder have longholes, so you can adjust a bit. You don't need screws for the plates, just lay it down and remove it easily
If you like my work, please buy me a coffee ^^
[](https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=4L74MQF85CTEJ&source=url)
BePrint veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!