Thingiverse
Insta360 Drifter
by ading12
16
Downloads
8
Likes
0
Makes
Insta360 drifter. The camera should fits snugly. You might have to resize by a small amount by heating with heat gun.
You would only see part of the wing in your recording. looks like a cross.
Printed with support for the tail. If its too big for your printer, just split the model at the tail then glue them back together. Then no support needed.
Tested with PLA and TPU. Both prints fine. Recommended printing with TPU for soft landing. One of the file has a straight slot for printing with hard material. The other one has tapered slot that looks nicer with soft material.
Just need 1/4 screws to secure the camera.
You would only see part of the wing in your recording. looks like a cross.
Printed with support for the tail. If its too big for your printer, just split the model at the tail then glue them back together. Then no support needed.
Tested with PLA and TPU. Both prints fine. Recommended printing with TPU for soft landing. One of the file has a straight slot for printing with hard material. The other one has tapered slot that looks nicer with soft material.
Just need 1/4 screws to secure the camera.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
