Thingiverse
Insta360 GO mount for TinyTrainer
door Haku3D
12
Downloads
13
Likes
0
Makes
This is a 20 degree tilt mount for the Insta360 GO on the Five33 TinyTrainer.
You can mount the GO camera upside down for better lens protection, this is footage of mine with the GO camera mounted vertically since I wasn't going to do any tricky/close proximity flying: https://youtu.be/qt2Y7svY5r0
Print in TPU at 0.2mm layer height, no support should be needed.
Direct download link from my website:
http://www.haku.co.uk/3D/TinyTrainer_Insta360_GO_20_degrees.stl
You can sell prints of this, but don't overcharge, and link back here.
Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive
You can mount the GO camera upside down for better lens protection, this is footage of mine with the GO camera mounted vertically since I wasn't going to do any tricky/close proximity flying: https://youtu.be/qt2Y7svY5r0
Print in TPU at 0.2mm layer height, no support should be needed.
Direct download link from my website:
http://www.haku.co.uk/3D/TinyTrainer_Insta360_GO_20_degrees.stl
You can sell prints of this, but don't overcharge, and link back here.
Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
