Thingiverse
insta360 go2 Tello mount
von andre2pi
3
Downloads
2
Likes
0
Makes
This is a remix from 2 designs made to fix the insta360 Go2 on top of the Tello.
I made in two pieces to reduce the necessity of support, but you still need very little support to print the base.
After printing both pieces you can glue them with your favorite glue.
I made in two pieces to reduce the necessity of support, but you still need very little support to print the base.
After printing both pieces you can glue them with your favorite glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!