INSTA360 ONE X2 Kite bracket V2.1

This is an upgraded version printed in TPU ( version one in PLA tends to break when jumping )

This bracket will hold the INSTA360 ONE X2 to the 2 front lines.
Can be easily installed and removed without losing the lines the lines.
Placed at any height but beware the higher up, the 2 front lines diverge and start pulling on the hooks.
Notice the SAFETY line side marked with S , the hooks on this side will allow the safety line to slide through when pulling the safety and flagging the kite.
On the other side the hooks are tight and will not slide on the line.
Optionally add a camera screw at the bottom to create an extra safety.
Tie with small rope or rubber band to one of the lines to add extra safety to avoid loosing the camera when crashing.

Enjoy your session