Thingiverse
Insta360 Pro Speaker Pole Mount
von bradisbell
5
Downloads
4
Likes
0
Makes
Mount your Insta360 Pro camera on a standard speaker pole/stand.
The existing camera base snaps into this this, and is held tight by 1/4"-20 screws. (Holes are included for all 5 screws, but you probably don't need them all.) Then, just place the camera with this adapter onto the pole.
STL files included for 1.5" and 35mm poles. Tested to fit on some Ultimate Support stands, which hold the camera very well.
This is designed for 1/2" long 1/4"-20 screws. If you're using longer screws, edit the OpenSCAD file as necessary. Additionally, everything is sized to be a pretty tight fit, but can be adjusted in the OpenSCAD file if needed.
The existing camera base snaps into this this, and is held tight by 1/4"-20 screws. (Holes are included for all 5 screws, but you probably don't need them all.) Then, just place the camera with this adapter onto the pole.
STL files included for 1.5" and 35mm poles. Tested to fit on some Ultimate Support stands, which hold the camera very well.
This is designed for 1/2" long 1/4"-20 screws. If you're using longer screws, edit the OpenSCAD file as necessary. Additionally, everything is sized to be a pretty tight fit, but can be adjusted in the OpenSCAD file if needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
