Slicer Discord
Insta360 X3 battery cap – Modèle 3D imprimable de MakerWorld MakerWorld
Electronics

Insta360 X3 battery cap

15 Téléchargements
2 Likes
11 Makes
Voir le modèle
I wanted a minimal battery cap, but couldn't find one. I found one case I could whittle down (in Tinkercad) to what I wanted, but it was too loose. I made it tighter. This fits perfectly tight on my original battery and a non-original. So the only thing that's left of the original model is the inside hole where one battery fits, and even that's been shrunk. So this is just the bit around the battery from the original case, with a little ledge around each end to make it easier to pull off. There is something similar to a layer shift on one side, but might just be an artifact from cutting and pasting. It works fine.
Catégorie
Electronics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection