Thingiverse
Insta360 x5 battery case
von voice2001
1
Downloads
1
Likes
0
Makes
Battery case for insta360 x5. There are slots for latches.
To remove the battery, you need to push it from below.
This battery case was designed to carry a spare battery when cycling or snowboarding. The plastic was chosen in a bright fluorescent orange color to make it easy to spot in the grass or snow.
The infill can be set to 0-20%, so there are only inner and outer walls (for greater strength, you can print with an additional wall, as in the attached image from OrcaSlicer). This is necessary both for greater flexibility and for a thermos effect, so the battery cools more slowly in cold weather or heats up more slowly in hot weather.
PETG is very well suited for this. PLA is more breakable
The wall thickness should be as thick as possible for your printer for greater strength.
To remove the battery, you need to push it from below.
This battery case was designed to carry a spare battery when cycling or snowboarding. The plastic was chosen in a bright fluorescent orange color to make it easy to spot in the grass or snow.
The infill can be set to 0-20%, so there are only inner and outer walls (for greater strength, you can print with an additional wall, as in the attached image from OrcaSlicer). This is necessary both for greater flexibility and for a thermos effect, so the battery cools more slowly in cold weather or heats up more slowly in hot weather.
PETG is very well suited for this. PLA is more breakable
The wall thickness should be as thick as possible for your printer for greater strength.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
