Thingiverse
Insta360Go2 wing holder
von Syl20M
3
Downloads
2
Likes
0
Makes
This is a relatively light holder to clamp the insta360Go and insta360GO2 in a wing.
a simple 3mm hole is required.
I assume it is universal for wings thinner than 20mm or 15mm.
This has to be printed in TPU since it folds around the camera.
Update 2021-08-26: V2 is lighter, and compatible with clamping on a 8 + 15mm shaft.
a simple 3mm hole is required.
I assume it is universal for wings thinner than 20mm or 15mm.
This has to be printed in TPU since it folds around the camera.
Update 2021-08-26: V2 is lighter, and compatible with clamping on a 8 + 15mm shaft.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
