Slicer Discord
Instax Mini Frame Fridge Magnet – 3D-printbaar model van MakerWorld MakerWorld
Decor

Instax Mini Frame Fridge Magnet

door morty · Decor
2.1k Downloads
1.8k Likes
1.4k Makes
Model downloaden
Check out my newest frame! Update: Added corner pockets to hold photo in frame. My wife asked for frames for her photos to put on the fridge. After multiple attempts, I got to one that she approved of! The frame is held by four 6x2 magnets. I got them pretty cheap on Amazon. They are press fit, I use a hand clamp and squish them in if I can't get them seated completely. The magnets are outside of the area of the picture, so the picture does not interfere with the magnets. There is a recess to fit the picture. It needs support, but I have it dialed in to peel off very easily. Honestly getting the support off the build plate is more difficult. Boost MeA simple way to display small photos where you’ll see them every day. Give it a boost if you think it deserves a spot on the fridge!
Categorie
Decor
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie