Thingiverse
Insulation Load Spreading Retaining Washer
door dmannock
6
Downloads
2
Likes
0
Makes
Spread the load / increase fixing area when mounting insulation/plasterboard with screws. 60mm Diameter.
TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm).
There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm).
There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!