Thingiverse
Intercom V6 bracket for Bell Qualifier Helmets
door PrintFail
5
Downloads
6
Likes
0
Makes
This is a simple bracket for fitting a chinese V6 intercom into Bell Helmets.
Sliding the bracket lip inside the bracket is not easy. I didn't have to use flexible material for that. For me PLA worked fine.
Intercom cable must go upwards and then slide in the bottom. I'll change this design in future revision.
Sliding the bracket lip inside the bracket is not easy. I didn't have to use flexible material for that. For me PLA worked fine.
Intercom cable must go upwards and then slide in the bottom. I'll change this design in future revision.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!