Interlocking MTG Drawers

This Is a remix of SenpaiCZ's Modular MTG Drower, I extended the size of the model to be just under the maximum size my printer could handle (174mm height). I also added a Colorless and Multicolor design, and included my version of the blank drawer.

Note: These drawers are designed for sleeveless cards.

I have printed the White, Blue, Green, and Red files so far, using the settings below, the outer drawer piece takes about 33 hours, and the inner drawer piece takes about 13 hours.

Slicing engine: Cura 15.04
Layer Height: 0.2 mm
First Layer Height: 0.3 mm
First Layer Width Factor: 100 %
Shell Thickness: 1.2 mm
Solid Top: Yes
Solid Bottom: Yes
Fill Density: 20 %
Bottom/Top Thickness: 0.8 mm
Print Speed: 30 mm/s
Infill Speed: 70 mm/s
Bottom Layer Speed: 20 mm/s
Skirt Minimal Length: 300 mm
Support: Everywhere
Support Type: Lines
Support Angle: 70 °
Plat. Adhesion: None
Support For Dual