Internal Kick Drum Microphone Holder

This is a solution to a problem I'm sure most people don't have, however... I needed it, and maybe someone else might as well. It's basically a kick drum mic stand that utilizes the tom mount holes in most bass drums. I needed it mainly because where I have my drum set, the bass drum is butt up to the wall, so I can't use a traditional bass drum mic stand. It has a channel cut into it to allow the cable to run to the microphone. You can use the normal tom arm mount screws to affix it to the kick drum, or if you are like me, I used a 3D printed M8x15mm thumbscrew that has held up so far. I'll link the model I used below for the thumb screw. It's just about perfectly sized for a 22in bass drum, anything bigger, you'll have to remix it and make it longer. Lastly, the threads at the end are the same threads as a standard kick drum mic holder that is on most of the mic stands that sit on the ground. So, you should be able to just take it off, and thread it on. Message me if you have any questions! Anyways, maybe you'll need it, likely you wont, but here it is anyways! Thumb Screw Model: https://www.yeggi.com/goto/n6OcnHZ9Z_7isajTyqOa19LHva65p_/X3_Pi9qLj4PCjlvD24trY6LS4oKGV18zTp7is4dihmqDIpKOhy8KJs7aq3_HtlpevoqCWqqeT6OLb38aht6jY193dmNV4vmafx6Oan9JtrqOTho8= If you want to support me, please consider buying me a coffee at the link below, it fuels my caffeine addiction and my ability to put out more designs. Thanks! buymeacoffee.com/ihitcircles