Thingiverse
IP camera stand for 4040 frame (Ender 3)
door pathia
17
Downloads
10
Likes
0
Makes
I needed a camera stand so my IP camera could look just above the bed of my Ender 3 Pro.
This way I can look directly below the nozzle, to check for spaghetti.
I created this thing in Tinkercad and it fits my Ender 3 perfectly.
It creates a 100x100 mm place to put your IP camera on.
Installation is easy: just remove the screws on the front left of the printer and you can slide it into the 4040 frame.
This way I can look directly below the nozzle, to check for spaghetti.
I created this thing in Tinkercad and it fits my Ender 3 perfectly.
It creates a 100x100 mm place to put your IP camera on.
Installation is easy: just remove the screws on the front left of the printer and you can slide it into the 4040 frame.
pathia publiceert ook op
15 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
