Thingiverse
Ip-Camera Wall Holder
por RenatoT
12
Descargas
12
Likes
0
Makes
Modeled in Cinema4D R23 with basic primitive managed with volume tools (voxels).
The main object is printed 0.2 mm layer, 3 shells, 25% infill. The screw is printed very well at 0.1mm layer size and concentric 100% infill. Just add 2 screws, 2 nuts and 4 washers.
I printed it without supports, just 2 bridge, but come out very well on Anycubic Vyper
The main object is printed 0.2 mm layer, 3 shells, 25% infill. The screw is printed very well at 0.1mm layer size and concentric 100% infill. Just add 2 screws, 2 nuts and 4 washers.
I printed it without supports, just 2 bridge, but come out very well on Anycubic Vyper
RenatoT también publica en
4 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!