iPad 2 holder for Ender 3 Pro

I had an old iPad 2 lying around and decided to mount it to my Ender 3 Pro as an Octoprint controller.

I printed it on edge with supports for the right section.

I was concerned about weight and balance so added v-slot extrusions on 3 sides.
It also has a little slack to move left or right depending on how your filament spool sits.

Designed in Vectorworks, but it does such a terrible job at creating solids and STL files that I won't be doing that again. If you have any slicing problems try running the STL through a repair site. I had do do that on the right segment, and have uploaded the repaired version.

The curves on the side and bottom aren't a perfect match, but the iPad is very snug.