iPad 7th/8th/9th gen mount for Sim Rig

Needed way to mount iPad to Sim Rig. Main use case is to use iPad as MCDU in Flight Sims. Found great wallmount from Bear_Grills and used it as base of this work. iPad slides in pretty well and is securely hold down because of the angle of the mount.Mountable with two M8 bolts and two T-slot nuts. Created a hole for tightening the front bolt from upside because there is not a lot space underneath.Print orientation can be seen from one of the images. Mount facing print bed. Supports only for the hole on the front (maybe not necessary) and the front part where charging port is located. Printed with 4 parameters 50% infill 0.2 layer height. Infill can be reduced, but because this very close to handbrake in my installation i wanted to make sure if i hit accidentally it when rallying it wont break down.