Slicer Discord
iPad Case (gen 6, 9.7-inch) – Modèle 3D imprimable de MakerWorld MakerWorld
Other House Models

iPad Case (gen 6, 9.7-inch)

463 Téléchargements
58 Likes
222 Makes
Voir le modèle
A simple case for a 6th-generation iPad (9.7-inch). This is a remix of a model by maximuska. I wanted a solid backing – needed to add a hole for the rear-facing microphone. The original model was a very tight fit but I found it was impossible to remove without destroying the case (I printed in PLA). I've added a millimeter on each side so the case stays on but is removable with some care. The tolerances are very tight so your mileage may vary!
Catégorie
Other House Models
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection