iPad Holder for Tesla Model 3

Disclaimer: This is strictly for when the car is in PARK. I take no responsibility for the misuse of this device.

You will need to add rubber bumpers or thin foam to protect the back surface, top edge, and glass part of the screen. You can use "cabinet bumpers" and the arms with recessed holes accommodate them. There is also arms for adhesive foam without the holes.

7 bumpers needed or a couple square inches of foam tape all available at your local hardware store.

I do print everything in inches (barbarian), so you may need the barbarian plugin to convert to metric within Cura.

**Update**
I just posted v2. This has a more narrow front bezel to not block the corners of the screen. I also added sides to reinforce the thinner bezel and to help stop the iPad from sliding out.