Thingiverse
iPad Support and Adjustable Stand
por MauiMacMan
10
Descargas
4
Likes
0
Makes
I will need to get revised photos up of the new layout! I made this from scratch for my Mom's iPad 2. Its five pieces that press fit together. The H support member, is printed in two halves that have to be glued together then placed in the upper hole of the S curve's. The base could be refined.
I revised the base and the H member so once constructed, you can flatten the contraption. Next, The long rod should be threaded through the base holes and bottom holes of the support S curves. You can heat the ends of the rod for flattening the ends so it doesn't come apart...or leave it loose for deconstruction and portability.
I know its, big, and not very expedient (5 hr print approx) but for Mom with clumsy fingers, it works great. I coated the bottom of the base with liquid rubber (Dipit) so it grips the surface of the table for safer and better iPad, iPhone support.
I revised the base and the H member so once constructed, you can flatten the contraption. Next, The long rod should be threaded through the base holes and bottom holes of the support S curves. You can heat the ends of the rod for flattening the ends so it doesn't come apart...or leave it loose for deconstruction and portability.
I know its, big, and not very expedient (5 hr print approx) but for Mom with clumsy fingers, it works great. I coated the bottom of the base with liquid rubber (Dipit) so it grips the surface of the table for safer and better iPad, iPhone support.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!