Thingiverse
iPad/Tablet Stand
von Squiddles42
0
Downloads
5
Likes
0
Makes
Originally designed for my Apple iPad Air 10.9-inch (2022, 5th Generation) with a case on it, but may work for other tablets as well.
It can hold my iPad Air in portrait mode just fine without tipping!
The lip at the bottom has a clearance of about 13mm so if you can measure the thickness of your device and make sure it is under 13mm.
It can hold my iPad Air in portrait mode just fine without tipping!
The lip at the bottom has a clearance of about 13mm so if you can measure the thickness of your device and make sure it is under 13mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
