MakerWorld
Office
Zum Modell
iPad / Tablet Under Desk Holder - Case Compatible
10
Downloads
2
Likes
6
Makes
iPad / Tablet Under Desk Holder / Mount I wanted a place to stow away the iPad when it was not in use, so I created this iPad under desk holder It was designed around the iPad 9 with a pretty big case, so it will work with many other tablets most likely Here are the dimensions of the holder, if your tablet is smaller than these dimensions, it will work for you: 10-5/8 in. long (270 mm) 7-11/16 in. wide (195mm) 1 in. thick (25mm) Due to the dimensions of this model, it does not fit on 1 plate so it prints in 2 parts that need to be either glued together or plastic welded together The holder does require some screws and there are several holes to choose from ( I did not use every screw hold when mounting mine and it is very sturdy even with 4-5 screws) There is also a large hole to access the charging port so you can charge the device during storage Prints with minimal supports that come off easy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
